Universal Intermittent Pilot Ignition Module

Flame Failure Response Time: 2 seconds maximum
PrePurge: Configurable to 30 seconds or no prepurge
Ignition System Type: Intermittent Pilot
Ignition Sequence: Continuous Retry
Typical Gas Control: VR8204, VR8304
Flame Sense: Single Rod or Two Rods
Ignition Source: Internal high voltage spark generator
Ignition Trials To Lockout: continuous retry
Lockout Timing: continuous retry
Ignition Trial Time (sec): 15 or 90 sec
Maximum Valve Load @ 24 Vac (Amps): 1A Pilot, 2A Main @ 165 F; 1A Pilot, 1A Main @ 175 F
Typical Ignition Hardware: Q345, Q3451, Q3452
Between Trial Time (sec): 5 minute delay after failed trial for ignition.
Overview
Universal intermittent pilot ignition module replaces multiple field installed intermittent pilot modules supplied by Resideo, Robertshaw, Johnson, and UTEC (HSC). Uses existing intermittent pilot burner. Includes cross reference, instructions, and accessories for easy replacement.
Features
• Replaces over 400 White-Rogers, Robertshaw and Resideo intermittent pilot ignition modules
• Provides ignition sequencing, flame monitoring and safety shutoff for intermittent pilot warm air furnaces and heating appliances
• Provides 100 percent pilot gas shutoff if pilot fails to light; after 6-minute delay, trial for ignition is repeated. Ignition trial/delay sequence is repeated until the appliance lights or call for heat is removed.
• For use with Natural or LP gas
• For use in single rod or dual rod/remote sense applications
• Includes spark cable adapters to allow field replacement of both Resideo and competitive controls without replacing existing spark cable.